This morning it should have ran with my primary schedule , but did not. It showed “offline”
I reset it, updated the firmware and tried to run the zones. The controller indicates everything is fine, but water doesn’t run.

When I try to test individual zones, it indicates it’s running, but no water ??

I ended up starting from the beginning. Removed controller, then added it back in.
Water still doesn’t run.

I need help quickly. Thanks,

oh, sure. here is the picture of the controller's wiring

    Can you be more detailed. I'm not very familiar to this. All the wiring is done by my husband.

    You see the white part of the sticker, that corresponds to the COM terminal. But you are not wired. Since the picture you sent is a bit blurry, Not sure which white wire you should connect, you can try both.

    Write a Reply...