Sprinklers aren’t running wifi says connected app says they are running but they aren’t

Have you checked your wiring? Maybe you have loose wiring.

    I just remembered, does this have something to do with the fact that I'm hooked up to a sensor?

      R.Good Yes, Imolaza does not support sensors now. Please remove it in order to be able to use the device properly.
      If you find that your app shows watering but actually no water comes from the nozzles. Please follow the step below to troubleshoot.

      1. Use the four buttons on the device to run all zones in turn.

        If water is coming out of all zones, your wiring is OK.

        If only one or two zones not running water. Please check for loose wiring at those two ports.

        If water does not come out of all zones. Please rewire the controller according to the reference diagram in our manual.

      2. If, after following the above steps, the water still does not come out through the app test. There may be an error in the operation of the app. Please take a photo of the wiring, then contact us via our official email address with the picture and your old controller's brand and model. We will solve the problem for you as soon as possible.

          2 months later
          2 years later

          Got the same problem app Test running no water! is frustrating!

          Write a Reply...